AOpen AK75 User Manual download pdf (Page 41)

Hardware Installation

2.8.14 Wake-On-LAN Connector

Function

+5VSB

Ground

WOL

The Wake-On-LAN connector is used to connect to a LAN card

that has the same connector. This function will allow the network to

remotely power-on a Soft Power Down (Soft-Off) PC. However, if

your system is in the Suspend mode, you can power-on the system

only through an IRQ or DMA interrupt.

To use the Wake-On-LAN function, you must enable Resume on

LAN/Ring (Wake Up Events field) in the Power Management

Setup of the BIOS. Your LAN card package should include a cable.

Connect one end of the cable to the wakeup header on the card

and the other end to location J10 on the system board. The

network will detect Magic Packet and assert a wakeup signal to

power-up the system. Refer to the add-in cards manual for details.

Note: Your LAN card must support the remote wake up function.

Important:

The 5VSB power source of your power supply must support

≥

720mA.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 94 95

No comments

AOpen AK75 User Manual Page 41